Independent compared, no shop of our ownEvery day new deals and codesSupplementScore on every productTraining, food and supplements in one app. Discover Kroton
Knowledge base
Training

Push pull legs routine: a 6-day plan to build muscle

Updated on 22 October 2026

A push pull legs routine splits your training into pushing muscles (chest, shoulders, triceps), pulling muscles (back, biceps) and legs. Run it over six days and every muscle group gets trained twice a week, with one rest day and sessions of 60 to 75 minutes. In this version the shoulders get their main work on leg days, and most exercises use two sets of 10 to 16 reps that you push a little further each week.

In short

  • Week: push, pull, legs and shoulders, push, pull, legs and shoulders, rest.
  • Every muscle group twice a week; sessions of 60 to 75 minutes.
  • Mostly 2 sets per exercise of 10 to 16 reps.
  • Add weight or reps every week: that is what makes the plan work.

How does the 6-day split work?

You train six days in a row and take the seventh off, either complete rest or something light such as a walk. The order is day 1 push, day 2 pull, day 3 legs and shoulders, then the same three again on days 4 to 6. Training each muscle twice a week gives it a fresh stimulus while leaving two or three days to recover before the next session. Each day mixes compound and isolation work: you start with a heavier pressing, rowing or leg movement and finish with cable and dumbbell exercises for the smaller muscles.

Why aren’t the shoulders on push day? They already work hard during pressing for chest and pulling for back. Putting the direct shoulder work on leg days spreads the load, so your shoulders are fresher for it and less likely to be overloaded. If six sessions a week is too many for you, our guide to the best training split shows which set-up fits three, four or five days.

Days 1 and 4: push (chest, shoulders, triceps)

Day 1

  • Dumbbell bench press: 2 sets of 10–12 reps
  • Incline Smith machine bench press: 2 × 14–16
  • Incline cable fly: 2 × 10–12
  • Decline cable fly: 2 × 14–16
  • Dumbbell overhead triceps extension: 2 × 10–12
  • Cable crossover triceps extension: 2 × 14–16
  • Single-arm cable triceps pushdown: 2 × 14–16

Day 4

  • Machine chest press: 2 × 10–12
  • Incline dumbbell press: 2 × 14–16
  • Incline cable fly: 2 × 10–12
  • Seated cable or machine fly: 2 × 14–16
  • Cable overhead triceps extension: 2 × 10–12
  • Single-arm cable triceps pushdown: 2 × 14–16
  • V-bar triceps pushdown: 2 × 10–12

Days 2 and 5: pull (back, biceps)

Day 2

  • Rope lat prayer: 2 × 12–16
  • Wide-grip cable row: 2 × 10–14
  • Iliac lat pulldown: 2 × 10–12
  • Chest-supported cable row: 2 × 14–16
  • Hammer curl: 2 × 10–12
  • Cable biceps curl: 2 × 14–16
  • Supinated dumbbell curl: 2 × 10–12

Day 5

  • Wide-grip cable row: 3 × 10–12
  • Single-arm lat prayer: 2 × 14–16
  • Close-grip cable row: 2 × 10–12
  • Lat pulldown: 2 × 14–16
  • Hammer curl: 3 × 10–12
  • Cable biceps curl: 2 × 10–12
  • Bayesian cable curl: 2 × 10–12

Days 3 and 6: legs and shoulders

Day 3

  • Leg extension: 2 × 12–16
  • Hip thrust: 3 × 10–12
  • Bulgarian split squat: 2 × 10–12
  • Calf press: 2 × 14–16
  • Dumbbell shoulder press: 3 × 10–12
  • Reverse cable fly: 2 × 10–12
  • Dumbbell lateral raise: 2 × 14–16

Day 6

  • Leg extension: 2 × 10–12
  • Smith machine hack squat: 3 × 10–12
  • Romanian deadlift: 2 × 10–12
  • Calf press: 2 × 14–16
  • Dumbbell shoulder press: 3 × 10–12
  • Reverse cable fly: 2 × 10–12
  • Dumbbell lateral raise: 2 × 14–16

How to progress, and when to rest

Two sets per exercise is not a lot, so make them count. Warm up with one or two lighter sets of the first exercise, then take each working set close to the point where you can’t do another clean rep. Then add a little every week. Once you reach the top of the rep range in both sets, for example 12 reps on an exercise with 10 to 12, increase the weight and work back up from the bottom of the range. That principle is explained in detail in our article on progressive overload.

Six sessions a week only works if you recover. Use the rest day properly, sleep enough and eat enough protein. If your weights stall or drop for two weeks in a row and you feel flat, take an easier week before carrying on. How many sets per muscle you need overall is covered in how many sets per muscle group.

Frequently asked questions

Is push pull legs good for beginners?

The split itself is, but six days a week is a lot when you are starting out. Beginners usually do better with three or four sessions, for example push, pull and legs once each, before moving up to six.

How long should a push pull legs session take?

Around 60 to 75 minutes with this plan, including warming up. If you rest a long time between sets, it will take longer.

Can I do push pull legs three days a week?

Yes, but each muscle group then gets one session a week instead of two. If you can find a fourth or fifth day, a split that trains every muscle twice a week is the better choice.

Read more

All articles